Chrysler Conquest 1988 Service Manual page 471

WIPER AND WASHER SYSTEM
- Window Washer
8-221
SERVICE POINTS OF REMOVAL
1. REMOVAL OF WASHER TANK
(1) Remove the battery and the battery tray.
(2) Remove the washer tank mounting bolt.
(3) Remove the washer tank.
16Y155'
Washer
nozzle
Marking
position
6. REMOVAL OF WASHER TANK
(1) Remove the right rear side trim, the high floor side
panel, and the high floor side frame.
(2) Remove the washer tank mounting screws, and then
take out the tank.
8. REMOVAL OF WASHER NOZZLE
(1) Remove the roll bar trim.
(2) Remove the nut, and then remove the nozzle.
SERVICE POINT OF INSTALLATION
4. INSTALLATION OF WASHER NOZZLE
After the grommet is installed, pull out the washer tube
until the marking position is slightly visible.
NOTE
Make sure that the washer tube is routed between the
wiper link rod and cowl top outer panel.