Chrysler Conquest 1988 Service Manual page 442

8-192
LIGHTING SYSTEM
- Service Adjustment Procedures
' 'ertical
;:
center
Vehic,d line ahead of
axis
left headlight
ri
J
Height of
/'light centers
K ----l
I\
High intensity
area
I I
I Vertical center
area I
I I
I 1 I
16K77 I
AIMING WITH SCREEN
HEADLIGHT AIM PREPARATION
Place vehicle on a known level floor 7.6 m (25 feet) from aiming -
screen or light colored wall. Four lines of adhesive tape or iike
-
are required onscreen or wall:
I. Position a vertical tape so~that it is aligned with the veh?cle 2
center line. ~~
-
2. Position a horizontal tape with reference ta center line of f
headlight.
3. Position a vertical tape on-the screen with reference to the _
center line of each of headlights.
VISUAL HEADLIGHT ADJUSTMENT
1. A properly armed lower beam WIII appear -on the armrng
screen 7.6 r-n (25 feet) In front of the vehicle. The shaded -
area as shown In the illustratron rndicates; high Intensity
zone.
2. Adjust low beam of headlights to match the low beam ~I
pattern of the right and left headlights.
LUMINOUS INTENSITY MEASUREMENT
Measure the lumrnous rntesrty ot headlights with-a photo- ~.
meter m accordance with the instruction manual prepared-by
the manufacturerof the photometer and make sure that the:IIy
luminous intensrty
IS
within the following limit,
Limit: 20,000 cd or more
NOTE
.-
(1) When measurrng the lumrnous intensity of headlight, keep .-;
the engine at 2,000 rpm and have the battery charged.
(2) If there areIspecrtic regulations for luminous intensity of. .=
headlights in the region where the vehicle is operated, 1
make sure that the rntenay conforms to the requirements mu:
of such regulations.
Vertical center line
- FOG LIGHT AIMING
NOBIIEA
1. Place vehicle on a known leveffloor 7.6 m (25 f:eet) from--;
aiming screen or light colored wall.
2. Use adjusting screw to adjust the top end of high intensity _
zone to dimension A.
SA
Height of fog
light center
High intensity
Level floor
area center
/"""""""/""'