Chrysler Conquest 1988 Service Manual page 400

8450
IGNITION SYSTEM
- Ignition System
L
1ELlOE
-
(+) terminal
(-) terminal
\ /
0
-~ 1. ~-5
':
_^ --
4 '^
I
J
3EL061
lELO11
Stud
.-- ._
I
Mating
flange
= _
INSPECTION OF SPARK PLUG CABLES
pL-2
(1) Check the caps and coatings for cracks.
(2) Measure resistance.
Unit: kl2
-
INSPECTION OF IGNITION COIL
I. Measurement of resistance of primary coil
Measure resistance between terminals (+) and (--) pf ~_
ignition coil.
Standard value: 1.12 - 1.38 0
2. Measurement of resistance of secondary coil ~~
Measure resistance between terminal (+) of ignition coil
and high tension terminal.
Standard value: 9.4 - 12.7 kfZ
SERVICE POINTS OF INSTALLATION
9. INSTALLATION OF DISTRIBUTOR
(1) Check the distributor oil ring for damage and seat it
securely in the distributor housing groove. -1
(2) Align mating mark on distributor housing with mating ~
mark on distributor driven gear.
(3) Install distributor to cylinder head while aligning matrng
mark on distributor attaching flange with center of
distributor installing stud and tighten nut. _