Chrysler Conquest 1988 Service Manual page 1225

AUTOMATIC TRANSMISSION -
Automatic Transmission Assembly 21-q
03
Transmission case wall vacuum diaphragm
Note seated valve body \
\
38. Before installing vacuum diaphragm valve, measure depth
of hole in which it is inserted. This measurement deter-
mines correct rod length to ensure proper performance.
Vacuum Diaphragm Rod Selection
Measured depth "L" mm (in.) Rod length Part number
mm (in.)
Under 25.55 (1.0059) 29.0 (1.142) MD61 0614
25.65 - 26.05 (1.0098 - 1.0256) 29.5 (1 .I 61)
MD61 0615
26.15 - 26.55 (1.0295 - 1.0453) 30.0 (1.181) MD610616
26.65 - 27.05 (1.0492 -~ 1.0650) 30.5 (1.201)
MD610617
Over 27.15 (1.0689) 31 .o (1.220) MD610618
39.
O.D. cancel solenoid
JAT
40.
Install vacuum diaphragm.
Make sure that vacuum diaphragm rod does not interfere
with side plate of control valve.
Install downshift solenoid, O.D. cancel solenoid.
41. Install inhibitor switch. Check for proper operation in each
range using a circuit tester. Refer to On-vehicle Service.