Chrysler Conquest 1988 Service Manual page 742

<=7 Timing chain side
ENGINE
- Cylinder Head
-
SERVICE POINT§ OF REMOVAL
~_ em~Sealant appllcatlon
@ Timing chain side
position
Zare for not
:o clog the
)il hole with
seatant
5EN20'
1. REMOVAL OF CYLINDER HEAD BOLT / 2. BOLT
ETI
s;
Remove cylinder head bolts in sequence shown in illustra-
tion.
INSPECTION
* R&move sea%, sealing compound and carbon deposits
completely. After cleaning oil passages, apply compressed
air to make certain that the passages are not clogged.
l
Check the jet air passage and EGR gas passage for
ctogging. ~~ =~~~ =
l
Visually check the cylinder head for cracks, damage and
,water leakage.
l
Check
cylinder head gasket surface for flatness with a
straight edges as shown in illustration.
l
If flatness exceeds. service limit in any direction, either
replace cylinder head or lightly machine the cylinder head
gasket surface.
Flatness of cylinder head gasket surface:
Standard value
Max. 0.05 mm (.0020 in.)
Limit
0.2 mm t.008 in.)
Overall height:
Standard value 90.0 mm (3.543 in.)
Limit
.
89.8 mm (3.535 in.)
Caution
if cylinder block gasket surface has already been
ground, thickness of the removed stock should be
included in the grinding limit of -0.2 mm l-.008 in.).
SERVICE POINTS OF INSTALLATION
NOIODAB
4. INSTALLATION OF CYLINDER HEAD GASKET
(I) Clean
gasket
surfaces- of cylinder head- and cylinder ~
ZZ
block.
(2) Apply
sealant
oc equivalent at two positions- upper
ends of the cylinder ~block and chain case mating I
surface, as shown in the iHustration.
-
~
Specified sealant: MOPAR Part No. 4318034 or
equivalent