Chrysler Conquest 1988 Service Manual page 1048

=- __
-__ __ - - ,i --
-:-
REAR AXLE
- Torque Tube
Ed
(7) Drive the bearing into the extension shatt by using the
ET:
special tool. (Refer to P.3-32.)
a,;:
NOPE
D
Continue driving the b&ring in until the flange-surface <
Ed
of the,sp&al tool comes in contact with the edge of the
.I Em
-
torque tube.
YL
~~
(8) Install the snap ring by using snap rrng pljers to secure
-- m
G =
the bearing In place.
(9) Install the companion flange by properly aligning the ~-I
mating marks.
!!!!sez-
3. APPLICATION OF OIL TO TORQUE TUBE ASSEMBLY
TO FRONT SUPPORT BOLT
r
Apply oil to -the bolt on-its entire surface bef.sre its, is _ i
~~
installed.
', MEASUREMENT OF COMPANION FLANGE RUNOUT -
(1) Hold the extension shaft by applying the parking brake,
and tighten the companion flange mounting nut.
(2) Measure companion flange runout with a dial indicator.
. ..i
(3) If the companion flange runout exceeds the standard I -
value, change the phase of the companion flange and
extension shaft and measure the runout once again, ,,-
Standard value: 0.1 mm (.004 in.)