Chrysler Conquest 1988 Service Manual page 384

j ; y
".
p
-
.1 .I_ . .1 .___.-- w-m-
-z-
s&;~
8-133
STARTING SYSTEM - Starter Motor
=F
=
__
Retaining
Brush
Socket --
SERVICE POINTS OF DISASSEMBLY
6. REMOVAL OF BRUSH HOLDER
Slide the two brushes from-brush holder by prying retaining i
springs back.
i.- -
IXREMOVAL OF RETAINING RING
Ez=
Measure the pirrion shaft end play using feeler gauge for E-i
reassembly.
-
-
_
I -_
22. REMOVAL OF SNAP RING
w=
(1) Press the stop ring off the snap ring with suitable E
socket.
(2) Remove the snap rrng with screwdnver.
CLEANING STARTER MOTOR PARTS - _
1. Do not Immerse parts In cleanrng solvent. lmmerstng the
yoke and field co11 assembly and/or armature will damage
insulation. Wipe these parts wtth a cloth only,__
? Do not immerse overrunnrng clutch In cleanrng solvent.
L.
Overrunning clutch
IS
pre-lubricated at the factory and *"
solvent will wash lubrication from clutch.
3. The overrunning clutch may be cleaned wrth ~a brush ~
morstened with cleaning solvent and wiped dry with a cloth.