Chrysler Conquest 1988 Service Manual page 1067

REAR AXLE
- Differential Carrier
3-49
SERVICE POINTS OF REASSEMBLY
NOBIRBA
. CLUTCH PLATE FRICTION FORCE ADJUSTMENT
Before assembly, use the following method to adjust
clearance between the spring plates and differential cases
(for clutch plate frictional force adjustment) when installing
the internal components into the differential case.
(1) Stack up the friction discs and friction plates two each
on each side as illustrated. Find combination that gives
standard difference in thickness between the two
sides.
Standard value: 0.05 mm (.0020 in.)
NOTE
The thickness of new friction plate and friction disc is
1.70 mm (.0669 in.).
I
11 S674
(2) Stack up spring disc and spring plate one each on each
I
side as illustrated. Find combination that gives smallest
difference in thickness between- the two sides.
NOTE
The thickness of new spring disc and spring plate is
1.70 mm (.0669 in.).
11 S673
(3) Assemble the pressure ring internal parts (differential
pinion shaft, differential pinion gear and side gear),
friction discs and friction plates and measure the overall
width as illustrated.
(4) Determine the sum (C) of thickness of spring discs and
spring plates and measurement taken in step (3) above.
(5) Determine the dimension (D) between contact surfaces
of spring plates when differential cases (A) and (B) are
combined.
D=E+F-G
(6) Adjust the spring disc thickness so that the spring plate
to differential case clearance (D - E) becomes the
standard value.
Standard value:
0.06 - 0.20 mm (.0024 - .0079 in.)