Chrysler Conquest 1988 Service Manual page 882

24-6
HEATERS
- Service Adjustment Procedures
Mode selection
2OY
1587
SERVICE ADJUSTMENT PROCEDURES
TEMPERATURE CONTROL SYSTEM ADJUST-
MENT
MODE SELECTION LEVER
1. Set the mode selection lever to every position to operate
the blower. Check to see that the air blows out correctly
according to the lever posrtrons.
2.
If air does not~blow out from the outlets matched with the :
mode selection lever position, adjust the mode selection
control wire. If then result of the adjustment is unsatisfac- mZ
tory, then adjust the damper.
Adjustment of the Mode Selection Control Wire
1.
2.
3.
4.
5.
6.
7.
8,
Disconnect the defroster duct at the driver's seat~side from
the heater unit and the-defroster nozzle,
Disconnect the mode selection control wire from the heater. _
unit's clip.
Set the mode selection lever of heater control to the "XL? "
position. ~~
Turn the mode selection damper lever completely to the
left.
Connect
the~mode
selection control wire to the-air outlet
changeoverdamper lever, and to the clip part of the heater
unit.
Caution
Be careful that the lever does not move when clipping.
Check
that
the heater control mode selection lever moves
smoothly with some resistance at each position and air
blows outfrom the outlets matched with the lever position.
If air blows out from the outlets not matched with the mode ._
selection lever position eden after control wire adjustment,
adjust the "VENT" damper and "FOOT/DEF" -damper.
Y
Connect thedriver's side defroster duct to the heater unit
and defroster nozzle.
Adjustment of the Damper
1. Disconnect the mode selection control wire from the mode ~_
selection damper lever and the heater unit's clip.
2. Adjust the "VENT" damper as follows:
-.
(1) Unlock the mode selection damper lever clip and -
disconnect the link for the "VENT" damper from the _
mode selection damper lever.