Chrysler Conquest 1988 Service Manual page 1059

REAR AXLE - Differential Carrier
3-41
(5) Fit the selected drive pinion rear shim(s) to the drive
pinion, and press-fit the drive pinion rear bearing inner
race by using the special tool.
. DRIVE PINION
PRELOAD ADJUSTMENT
Without Oil Seal
Adjust the drive pinion rotating torque by using the
following procedure:
(1) Fit the drive pinion front shim(s) between the drive
pinion spacer and the drive pinion front bearing inner
race.
(2) Tighten the spline coupling by using the special tools.
NOTE
Do not install oil seal.
(3) Measure the drive pinion rotating torque (without oil
seal).
Standard value: 15 - 25 Ncm (1.3 - 2.2 in.lbs.1
(4) If the drive pinion rotating torque is not within the range
of the standard value, adjust the turning torque by
replacing the drive pinion front shim(s) or the drive
pinion spacer.
NOTE
When selecting the drive pinion front shims, if the
number of shims is large, reduce the number of shims
@,a minimum by selecting the drive pinion spacers.
(5) Remove the spline coupling and drive pinion once again.