Chrysler Conquest 1988 Service Manual page 758

9-58
ENGINE
- Piston and Connecting Rod
End of
side rail
1 ENOGS
1 EN061
Side rail
spacer
6EN04'
-
I
'iEN
White pant
(Front m%k) Notch (Front mark)
5EN30;
(2) To install-the srde rai!, trrst place oneLend Ln the gap =
betweenthe groovezrnd the spacer.
While holding the end firmly, press the portion to be 11
inserted with finger as illustrated until the side rail is in ~
position.:-- : -
Caution
Do not use piston ring expander to install the side
rail.
--
8. INSTALLATION OF NO. 2 PISTON RING / 7. NO. 1
PISTON RING
Using a piston ring expander, install No. 2 and No. 1 piston
ring.
".
Caution
1. The No. 1 and No. 2 piston rings have a different
cross section. Be sure to install them in correct
positions.
2. Install the No. 1 and No. 2 piston rings with the size
mark and maker mark on ring surface toward the
piston top.
5. INSTALLATION OF PISTON AND CONNECTING ROD
ASSEMBLY
(1) Apply engine oil amply to the piston.-rcr_utside, piston ~
rings and- oil ring. -
(2) Position the gaps of the pistonr&@s?EdoTT ring (side r
rails, spacer) as illustrated. ~~~~~~~ ~.
.=
s
~-
(3))fnsert~the piston and conne&rg rod assembly from the ~1
cylinder top with the front marks on piston top and T
connecting rod facingthe timing belt side of engine. -
F~
I
er
2. INSTALLATION OF CONNECTING ROD CAP
When new connecting rod is installed, make sure that
identification mark and notch- are on same side.