Chrysler Conquest 1988 Service Manual page 670

PROPELLER SHAFT AND UNIVERSAL JOINTS
- Propeller Shaft
Large "C
clamp
D1051i
D1051:
D10514
I
Apply grease
2. REMOVAL OF JOURNAL BEARING / 3. JOURNAL
(1) Force ouYthe journal bearings from the propeller shaft _
E
yoke with
a large "C" clamp by the following proce- pY E
dures: ~-7
@ Install collar to the large "C" clamp proper.
@ Pressa journal bearing by using the large "C" clamp
5
to force out the journal bearing on opposite side. 7p
E
I'
& Pull out-the journal bearing from the yoke.
NOTE
If the-journal bearing is hard to remove, strike the
E
yoke with a plastic hammer.
_
- _
($ Press-the~ journal shaft by using the large "C" clamp
to force out the remaining bearings.
@ Pull out the journal.
(2) Separate the journal together with the yoke from the
propeller shaft yoke. ~
(3) Force out'the journal bearings from the yoke~~and then
take out the journal from the yoke.
SERVICE POINTS OF REASSEMBLY
NlGGHAJ
3. INSTALLATION OF JOURNAL / 2. JOURNAL BEARING
(1) Apply specified grease to the following parts of univer-
sal joint kit:
@ Shaftsland grease=sumps of journal
@ Dust, seal lips
@ Needle roller of bearings
Specified grease: MOPAR Multi-Mileage Lubricant
Caution
Part No. 2525035 or equivalent
Do not excessively apply grease. Otherwise, faulty
fitting of bearing caps and errors in the selection of
snap rings may result.