Chrysler Conquest 1988 Service Manual page 1015

LUBRICATION AND MAINTENANCE
- Maintenance Service
O-17
09Y631
(1) Loosen the oil pan screws and tap the oil pan at one corner
to break it loose and allow automatic tra~nsmission fluid to
drain.
(2) Drain automatic transmission fluid remaining in bottom of
oil pan after its removal.
(3) Install oil pan with new gasket and tighten~oil pan screws, 6
to 8 Nm (4.4 to 5.7 ftlbs.).
(4) Pour 5 liters (5.3 qts.) of "DEXRON II" ATF into case
through dipstick hole. [Total quantity of ATF required is
approx. 7.2 liters (7.6 qts.).
Actually however, approx. 5.5 liters (5.8 qts.) of fluid can be
replaced because rest of fluid remains in torque converter.]
(5) Start engine and allow to idle for at least two minutes.
Then, with parking brake on, move selector lever momen-
tarily to each position, ending in "N" Neutral position.
(6) Add sufficient ATF to bring fluid level to lower mark.
Recheck fluid level after transmissibn is at normal operating
temperature.
Fluid level should be between upper and lower marks.
Insert dipstick fully to prevent dirt from entering transmis-
sion.
COOLING SYSTEM (Check and service as re-
quired)
NOOSBEA
Check the cooling system parts, such as radiator, heater, and
oil cooler hoses, thermostat and connections for leakage and
damage.