Chrysler Conquest 1988 Service Manual page 1212

21-90 AUTOMATIC TRANSMISSION
- Automatic Transmission Assembly
E ~5
Esz:
se;=
JAT069 1
JATO
29. Remove outj?Kt shaft with governor.
30. Remove governor thrust ~washer and needle bearing.
~_
31. Remove one-way clutch inner race attaching hex-head
slotted bolts using the special tool.
32. Remove oneway clutch inner race, return thrust washer, =
low and reverse return spring and spring thrust ring.
33, Using an air @E.Gth a tapered rubber tip, carefully apply air r
pressure to remove low .and reverse brake piston.
a
34. Pry off snap-Gig (1) from both ends of parking brake lever
(2) and remove the lever. Back off manual shaft lock nut (3) .-
and remove manual plate (4) and parking rod (5).
35. Remove inhibitor switch and manual shaft by loosening two
retaining bolts,