Chrysler Conquest 1988 Service Manual page 1146

.__
MANUAL TRANSMISSION
- Transmission
Shift rail
14501
5.5-6.0 mm
(22.-.24 In.)
Seal with sealer
5.5-6.0 mm
(.22-.24 in.)
5.5-6.0 mm
--i k-- L22-,24 in.)
134041
Ball
Poppet spring
I I
Small end
14501:
Neutral rety ~~ &I1
Resistance spring
finrYE ', t
Neutral return
plunger A
Net&al return
ipring
plunger B
119CJ:iff
(2) Drive in Spring pin so as to place slit in drrectron ot
center line of shift rail.~-Drive_in spring pin for 3rd-4th and
1
1 st-2nd shift forks inthe same manner.
NOTE
.~
Do not reuse spring spin.
24. ~~L~~iON OF STEEL BALL / 23. POPPET SPRING /
(I) Insert steel ball and poppet spring into each -shift rail.
Tighten plug to specified position. _ .
-- (2))lnsert~pC5j5pet spring with small end on ball stde. Three
springs are identical _fo one another.
(3) After installation. sea! plug head withy sealer.
Specified sealant: 3M Super Silicone 8662 or
equivalent
15. INSTALLATION OF EXTENSION HOUSING
When installing the extension housing, put the change
shifter down inthe arrow:direction, and fit control finger in
groove provided in selector.
14. INSTALLATION OF NEUTRAL PLUNGER B / 13. NEU-
TRAL PLUNGER A / 12. SPRING / 11. PLUG / 10. BALL /
9. SPRING
Install neutral return plungers% and B and springs. Then -=
install steel ball a.nd resistance spring, and tighten the seal
plugs.