Chrysler Conquest 1988 Service Manual page 1213

AUTOMATIC TRANSMISSION
- Automatic Transmission Assemblv
21-91
REASSEMBLY
NPILF- -
When installing/assembling needle bearing, bearing race, snap
ring and O-ring (seal ring), use the following illustration as a
guide to installation procedures and locations.
#2
#7 #8
JATOOI 6
JATI 31
1. Before proceeding with the reassembly of all components,
it is important to verify that the case, housing and parts are
clean and free from dust, dirt and foreign matter (use air
gun). Have a tray available with' clean transmission fluid for
lubricating parts.
Petroleum jelly can be used to secure washers during
installation. All new seals and rings should have been
installed before beginning final assembly.