Chrysler Conquest 1988 Service Manual page 604

7-18 COOLING
- Radiator
I
SERVICE POINTS OF INSTALLATION
NO'IQDAD
11. INSTALLATION OF SHROUD / 14. SHROUD
When installing the shroud to the radiator, be sure to 1
tighten the ground wires with the bolts which senses also
I-
for mounting the shroud.-
Connect the thermosensoFto
the
connector and iiistall the
2
cap on the thermosensor to project it from water.
~-
NOTE
1. Fill the radiator and reserve tank with clean engine _,
coolant. =
2. Run the engine until the engine coolant has warmed wp
-
enough so_ that the thermostat valve opens, and then
stop the engine.
3. Remove the radiator &p, pour in the engine coolant
until it is up to the filler neck of the radiator, and then fill
.i
the reserve tank to the upper level.
4.
Check
to be
sure that
there
is no
leakage
from the mL
radiator, hose or connections.
-.
: