Chrysler Conquest 1988 Service Manual page 908

24-32
AIR CONDITIONING
- General Information
6. For OperaTtiCn Display LED (Orange) and Blower Switch -_
The LED operation IS synchronized with switch operation.
Ignition at ON and control In AUTO mode:
(I) Blower speed level IS determined by deviation of =_'
interior temperature trom set temperature.
(2) Switch lamps are all IIt dim.
Manual setting:
(I) Blower speed level
IS
set as selected (OFF", Lo or Hi). ~_
(2) Switch lamps and LED's are lit for set keys only.
' If OFF-key is pressed, ECONO operaCon display LED, ==
ECONO~ switch lamp and AUTO switch lamp are IIt
dim (wrth compressor OFF).
7. TemperaturCControl Switch
(I ) After ignition switch
IS
set to ON, lamp
IS
always IIt dim.
(2) Beep sound IS produced once at every set temperature
change. (Setting changes at 1°F increments from 65 to
90°F.)
(3) If pressed slmultaneausly, no change occurs rn Set I
Temperature. No beep sound.
.-
(4) No etfect on other switches.
(5) If the switch
IS
kept pressed, set temperature conrlnues IT
to change down to 65°F or up to 90°F. [Below 65°F or
above XC?, neither set temperature change nor beep
sound
IS
caused even It the switch IS pressed). ~~
8. AUTO OperaTitin Display LED (Orange) and AUTO Switch .i
The LED opei%mn and AUTO switch operation are synchro-
ntzed.
(I) Ignition SWlTch ON:
AUTO switch lamp and LED only are lit. (Other switch
lamps are lit dim.) Operation drsplay LED's are as
described in the respective displays.
Manual setting:
When the blower speed level and air flow Fade are ~ I
selected and compressor IS In OFF mode, AUTO swrtch
_
lamp
IS
lit dim and AUTO LED indicatoris ott. 1~ case of
#2/r selection mode and ECONOMY mode -;zelection, 1:
however--AUTO switch lamp and LED will be lit. 1
(2) If AUTO key is pressgd again, AUTO mode is set and ._
AUTO s@Ztch lamp and LED will be !rt except when
temperature is same as seT temperature.