Chrysler Conquest 1988 Service Manual page 1206

21-84
AUTOMATIC TRANSMISSION
- Automatic Transmission Assemblv
I , . ,
JATO31
SERVICE NOTES
Before proceeding ~with disassembly, thoroughly clean the
outsrde of the transmission.. It is important to prevent con-
tamrnatron by dirt or other foreign matter.
Disassembly should be done In a clean work area.
;_
Use a nylon cloth or paper towel tor wrprng parts clean.
Common shop rags can leave lint that mrght interfere with the ~.
transmisston's operation.
The transmissio_rrconsists ofrmany small parts that are quite
alike in construction yet machined to very close tolerances.
When disassembling parts, be sure to place them in order in _~
part rack so they can be put back In the unit In their proper
posrtrons. All parts should becarefully cleaned wrth a general
purpose, non-flammable solvent before inspection or reassem-
bly. Gaskets, se&, and similar parts should be replaced. It is
also very rmportant to perform functional tests whenever
designated.
DISASSEMBLY
The steps below show disassembly of the following compo-
nent parts down to sub-assembly configurations. -
9 Oil pump assembly
l
Front clutch assembly
@ Rear clutch assembly
d Direct clutch assembly
@ Control valve assembly
@ Governor valve assembly
l
F Yanetary gear assembly
For repair procedures of each sub-assembly, refer-to page
y- 1 05 to 21-1z!3.
1. Remove tor@E converter and drain transmission fluid i
through end pf rear extension.
ids - ._
~-
2. Remove governor tube.