Chrysler Conquest 1988 Service Manual page 1223

AUTOMATIC TRANSMISSION
- Automatic Transmission Assemblv
21-101
Dack
and race bearing
JAT00.10
JATI 6E
Spring
Accumulator plug
I
Snap ring '
.lAT17(
q
: Apply sealant
JATI 71
26. Apply automatic transmission fluid to seal ring of direct
clutch, then install O.D. bearing and race, O.D. thrust
washer
and
O.D. pack on drum support. Make sure that
brake band strut is correctly installed.
27. Apply automatic transmission fluid to O-ring of oil pump,
then install needle bearing, race and oil pump.
Before installing oil pump housing and oil pump on O.D.
case, ensure that they have been centered properly.
Refer to Oil Pump in Component parts.
28. Adjust O.D. band. Adjust torque piston stem to the
specified value. Back off two full turns and secure with lock
nut.
Piston stem: 12 - 15 Nm (9 - 11 ft.lbs.)
Piston stem lock nut: 15 - 39 Nm (11 - 29 ft.lbs.)
29. Using an air gun with a tapered rubber tip, test O.D. band
servo operation.
30. Install accumulator parts, then secure with snap ring.
31. Remove the two bolts used to temporarily tighten O.D.
case. Apply sealant to seating surfaces of converter
housing at bolt locations. Install converter housing on O.D.
case and tighten converter housing securing bolts.
Converter housing bolt: 44 - 54 Nm (33 - 40 ft.lbs.)