Chrysler Conquest 1988 Service Manual page 1218

21-96 AUTOMATIC TRANSMISSION - Automatic Transmission Assembly
gg-
- -~
JAT151
JAT152
- Transmission
Clutch pack A
1:
Front end play
2: Total end play
Needle bearing
JAT153
(5) Measure from top of drum support shaft (front clutch _
e*,
F
and rearclutch side) to instalLed gasket (dimension C).
(6) Install thrust washer. Measure trom top ot drum
m"
support shaft (front clatch and rear clutch-side] to thrust -
washer (dimension a.
E
(7) Difference between dimension [A - 0.1~ mm (.004 in.) - ~- s-m
B] and (C - D).is front end play and must be within ??
standard value.
Standard value: 0.5 - 0.8 mm (.020 - .031 in.) EEm.-
Front end play can be adjusted with high-reverse clutch
&
(Front) thrust washers of different thicknest
.~ _
Available High-Reverse Clutch (Front)
Thrust Washer
Thickness mm (In.1
1.3 (.051)
1.5 i.059)
1.7 t.067)
1.9 i.075)
2.1 t.083)
2.3 (.0911
2.5 m38)
2.7 i.106)
Part number
MD610212
MD610213
MD610213
MD610215
MD610216.~
MD61021 7
MD6lC)218
MDU02 19
16. Adjust total end play asfollows:
This adjusttirit is seldom required because this type of _
thrust bearing and race will normally show very little wear.
We also have a standard tolerance of 0.25 to 0.50 mm
(.0098 to .0197 in.). However, we are presenting correct ~_
checking procedure.
=
(1) Measure dimension &using instructions-in steps (I), (21
and (3) under para. 15 above.
(2) Measure-dimension C using instructions in step (5) 1
under para. 15 above.
(3) Differerzz between dimension [A - 0.1 mm LOO4 in.)] ~_
;Ind C IS total end play and It must be wlthrn standard ~_
value.
Standard value: 0.25 - 0.50 mm (.OlO - .020 in.)
It difference betweeKIA - 0.2 mm (.008 in.)] and C IS
not wrthln tolerance, select proper srze 011 pump cover
bearlnq race.
--