Chrysler Conquest 1988 Service Manual page 1106

-
STEERING
- Steering Column and Shaft
F1352,
L
13F52F
F1352E
14. INSTALLATION OF JOINT BEARING
(1) Install the joint bearing (with the flanged surface facing
upward) on the steering shaft lower end.
(2) Align the-joint bearing hole with steering shaft hole, ~1
(3) Apply specified grease to joint pin B and insert in the .z
joint bearing.
Specified grease: MOPAR Multi-mileage Lubricant
Part No. 2525035 or equivalent
Caution
Be careful that the pin does not project over the
bearing surface.
9. INSTALLATIGN OF JOINT SOCKET
Fill the socketwith the specified grease, and then insert the
_
seat, spring and spring seat into it.
Specified grease: MOPAR Multi-mileage Lubricant Part
No. 2525035 or equivalent
8. INSTALLATlGiKGF JOINT PIN A
(1) Apply specified grease to joint pin A.
Specified grease: MOPAR Multi-mileage Lubricant
Part No. 2525035 or equivalent
(2) Insert the steering shaft lower end into the socket, and, --_
while holding the shaft downward, insert joint pin A by
hand.
6. INSTALLATiOlVOF JOINT PIN RETAINER
(I) Apply the-specified grease to the inside of the joint pin
retainer.
Specified grease: MOPAR Multi-mileage Lubricant
Part No. 2525035 or equivalent
(2) Attach the joint pin retainer, and secure it with the ~_
stoppers.~
Cover with the joint tiver.