Chrysler Conquest 1988 Service Manual page 444

LIGHTING SYSTEM - Headlight
lW152i
16Y158L
=--
SERVICE POINTS OF REMOVAL
eT
1.
4.
7.
8.
REMOVAL OF HEADLIGHT BEZEL
(1) Raise the- headlights by using the pop-up switch.
-
Disconnect the negative I-) battery terminal. ~ _ 5;
Caution
Because there is the danger of burning the coil of the
headlight relay by a reverse flow of power if the
headlight switch is used to raise the headlights and the
negative terminal of the battery is disconnected, be
sure to always raise the headlights, in this condition, by
using the pop-up switch.
(2) Remove.%he headlight bezel. .I~, .i. 2
REMOVAL OF HEADLIGHT HOUSING ASSEMBLY ' _= :
Remove the headlight housing assembly and the linkage ~_
coupling part.
;
NOTE
Remove the. linkage coupling part while holding the i
headlight hood by hand.--
REMOVAL OF AIR GUIDE PANEL
Refer to GROUP 23 BOW - Air Parts.
.;
_?~
: .-
REMOVAL OF POP-UP MOTOR
Remove the pop-up motor together with t :he horn.
IO. REMOVAL OF ARM
Put aligning marks on the arm and motor shaft before the-.:
arm is removed.
.; -
NOTE
When replacing the arm, put an alignment mark to a new ~
arm in the same location as made in the old arm.
~_
SERVICE POINT OF INSTALLATION
s
4. INSTALLATION OF HEADLIGHT HOUSING ASSEMBLY
(1) Use theelliptical holein the headlight hood to-adjust~the _
clearance between the headlight hood and the fender, I
and between the headlight hood and the header panel, --
so that they are equal.
-