Chrysler Conquest 1988 Service Manual page 244

Theft
protection label
For original parts
OOK619
For replacement parts
OOK62 1
ENGINE MODEL STAMPING
NOOCG-
_
The engine model number is stamped at the right front side on
the top edge of the cylinder block as shown in the following:
The engine serial number is stampe-d near the engine -model
number, and the serial number cycles, as shown below.
Engine serial number Number cycling
I-
BODY COLOR CODE
NOOCH-
.
R88
T87
wo9
x15
Maroon (Metallic)
THEFT PROTECTION
NOOCIAA
To provide protection againsttheft, the vehicle identification ~--
number (V.I.N.) is stamped on or its label is -affixed to the ,-;
following major engine, -transmission parts and body outer
panels.
Engine cylinder bjock, transmission housing, fender, quarter '!
panel, hood, rear hatch and bumpers.
The theft protection label is also affixed to each of major body, .<
outer panels for servicing, while the same informatioJ as the
theft protection label is stamped on the engine and transmrs-
sion for servicing.
Caution
1. Affix masking tape to the theft protection label before
repainting the original part. After painting, be sure to
remove the masking tape.
2. The theft protection label on the service part has
masking tape affixed to it. Therefore, paint the part as
is and remove the masking tape after painting.
3. Do not remove the theft protection label from the
original or service part.
zz --