Chrysler Conquest 1988 Service Manual page 1203

AUTOMATIC TRANSMISSION
- Transmission
21-81
YO9620
SERVICE POINTS OF REMOVAL
N21 LBAD
6. REMOVAL OF SPECIAL BOLTS
Remove six special bolts connecting the torque converter
and drive plate.
10. REMOVAL OF PROPELLER SHAFT
Refer to GROUP 16 PROPELLER SHAFT AND UNIVERSAL
JOINT - Propeller Shaft.
11. REMOVAL OF ENGINE SUPPORT REAR BRACKET
Support the rear of the engine with jack or similar device.
With the transmission assembly supported by using trans-
mission jack, remove the engine support rear bracket.
Caution
When the transmission assembly is supported on a
service jack, the supporting area should be as wide as
possible.
12. REMOVAL OF TRANSMISSION ASSEMBLY
Move the transmission rearward to separate it from engine.
Caution
The torque converter should not remain on engine
when separated.
SERVICE POINT OF INSTALLATION
NPlLDAD
12. INSTALLATION OF TRANSMISSION ASSEMBLY
Install automatic transmission reversing the removal proce-
dure and noting the following exception.
Before installing automatic transmission to vehicle, mea-
sure distance "A" to be certain that they are correctly
assembled.
Distance "A": More than 26 mm (1.03 in.)
Refill automatic transmission with fluid and check fluid
level.
Check inhibitor switch for operation. Starter motor should
be brought into operation only when selector lever is in "P"
and "N" positions (it should not be started when selector
lever is in 'ID", "2", "L" and "R" positions). Back-up light
should also light when selector lever is placed in "R"
position.