Chrysler Conquest 1988 Service Manual page 1044

3-26
REAR AXLE
- Drive Shaft
s-
sgr
Yllos
7
A
Drive
Inner race
shaft /-<
:*
llY702
SERVICE POINTS OF DISASSEMBLY
NOBJEAA
5. REMOVAL OF D.O.J. CAGE
Remove the D,O.J. tags from the D,O.J. inner race in the -E
direction of the B.J.
9. REMOVAL OF D.O.J. BOOT / 11. B.J. BOOT
Wrap vinyl tape around the.spline part on the D.O*J- side of
_
the drive shaft so that theD.0.J. and B.J. boots are not ~~
damaged when they are removed.
Caution
B.J. and shaft assembly cannot be disassembled. Do
not attempt to disassemble.
INSPECTION
NOBJFAA
* Check drive shaft for bend and wear.
@ Check B.J. for entry of water, toreign matter and rust.
1
@ Check B.J. ball for damage.
l
Check D.O.J. cage, D-0.3. inner race~and ball for rust, wear 1
and damage.
* Check D.O.J. outer race for wear and damage.
SERVICE POINTS OF REASSEMBLY
NOBJGAC
12. APPLICATION OF GREASE TO B.J. AND SHAFT ASSEM-
BLY / 11. B.J. BOOT
If the B.J. is to-be reused, pack the specified grease into the
r
B.J. boot. .
-
Specified grease: Repair kit grease
Overall capacity
95- 115 g (3.4-4.1 02)
Within B.J.
55 - 65 g (2.0 - 2.3 oz)
Within B.J. boot
40-5Og(1.4-1.802)
7. INSTALLATION OF D.O.J. INNER RACE / 5. D.O.J. CAGE ~--
(1) Install the D.O.J. cage~onto the drive shaft so that the ~_
smaller diameter side of the cage is~instal!ed first.
..;r
(2) Install the circlip on the drive shaft.
(3) Install the D.O.J. inner- race on the drive shaft with~its :I
smaller chamfering angle (17") side on the B.J. side, and
-:
then secure with the-snap ring.
_.. I