Chrysler Conquest 1988 Service Manual page 1014

O-16
- .d -a--
-... _.. _____ ______ ____~__~~__i__-~___ rr.". .-.. -..
LUBRICATION AND MAINTENANCE
- Maintenance Service
Transmission
OE
(31
(4)
(5)
Loosen the belt- tensron adjuster lock bolt.
~~
Turn the adjust bolt to reduce the belt tension;
~
.- =~z-:
Remove the belt.
(6) Install a new belt and turnthe adjust bolt to adjust the belt
tension. ~~
.~
Standard value: 7 - 10 mm (28 - .39 in.)
(7) Tighten the lock bolt.
(8) Tighten the a!ternator support bolt nut.
--.
MANUAL TRANSMlSSlbN (Inspect oil I&&)
NOOSBCD
Inspect each component for evidence of leakage, and check
the oil level by removing the filler plug. If the oil is contami-
nated, it is necessary to replace it with new oil.
(1) With the vehicle parked at a level place, remove the filler my
plug and make sure that the oil is at the same level as the --
lower surface of the threaded hoie.
~-~
(2) Check to see that transmission fluid is free of excessive pm-y ~~
contamination and has proper viscosity.
-
.-
_ -- --
TRANSMISSION FLUID (Replace)
(1) With the vehicle parked at a level place, remove the oil d~rain -~I
plug to drain transmission fluid.
(2) Replace packing with a new one and install the oil drain
plug.
(3) Pour transmission fluid in the filler plug hole unti!-the fluid is 1
at the same: level as the bottom of the plug hole.
Total transmission fluid capacity: 2.3 lit. (2.4 qts.)
AUTOMATIC TRANSfkSlON (Char&? fluid)
_
NOOSBDC
Drain the flurd and check whether there IS any evtdence of
cotitamrnacron.
Replenrsh with new fluid atter the cause of any conLamination I
has been corrected.