Chrysler Conquest 1988 Service Manual page 1052

REAR AXLE - Differential Carrier
SERVICE POINT OF REMOVAL
NOBBAC
4. DIFFERENTIAL CARRIER ASSEMBLY E!zE!F
Dismount the ditterential_ carrier from the rear-support
my'
BI
rnsulators bv rarsrng the drtterentral earner with-a jack. .-z _Z%:
.
'16E
-
-1lY242
INSPECTION BEFORE DISASSEMBLY
NO31EAE
Remove the rear supports and cover. Secure the working base -.~:
in a vice and then install the removed differential carrier 1
assembly.
a-
-.
FINAL DRIVE GEAR BACKLASH
UT
-~ c
With the drive pinion locked in place, measure the final drive ~~
gear backlash with a dial indicator on the drive gear.
NOTE
Measure at four points or more on the circumferentie of the yii
~~ 5
drive gear.
Standard value:
0.13 - 0.18 mm (.005 - .007 in.)
F-
DRIVE GEAR RUNOUT
--
Measure the drive gear runoot at the shoulder on the reverse -i
~~. +
side of the drive gear.
Limit: 0.05 mm (.002 in.)
SPLINE COUPLING RUNOUT
Measure the spline coupling runout with a dial indicator. __=
Standard value: 0.1 mm (.004 in.)
-.
--