Chrysler Conquest 1988 Service Manual page 1099

STEERING
- Service Adiustment Procedures
19-11
--CHECKING FLUID LEVEL
NlDFlAG
1. Start the engine on a level surface, and turn the steering-
wheel several times fully to the right and left while the
engine is idling.
2. Check the reservoir fo.r contamination.
3. Replace the fluid if it has bubbles or has become white.
4. Fill the reservoir with specified automatic transmission fluid
to the MAX IevelL
Specified fluid: MOPAR DEXRON or DEXRON II Auto-
matic Transmission Fluid Part No.
3549660 or 4131509, or equivalent
REPLACEMENT OF FLUID
N19FKAG
Check for contamination in the fluid reservoir. Foamy or cloudy
fluid should be replaced.
1. Remove the reservoir cap.
2. Disconnect the return hose- from .the reservoir tank and
remove the fluid.
3. Disconnect the high tension cable. Run the engine intermit-
tently several times with the starter motor, and remove the
fluid from the gear box.
4. Attach the return hose and supply the specified fluid.
5. Bleed the system and check the fluid pressure.
Specified fluid: MOPAR DEXRON or DEXRON II Auto-
matic Transmission Fluid Part No.
3549660 or 4131509, or equivalent
1.
2.
3.
4.
5.
6.
7.
AIR BLEEDING
Nl3FKAE
Check the stationary steering effort. If it is not within the range
of the standard value, it is possible that air has been mixed into
the system. Bleed the air from the system.
Make certain the reservoir is filled up.
Jack up the front wheels.
Disconnect the high tension cable.
While turning the steering wheel completely to the right
and to the left, turn the-engine over by using the starter
motor. Repeat this several times.
Lower the front wheels.
Connect one end of a vinyl tube of suitable length to the
breather plug of the gear box, and place its other end in a
container.
Start the engine and idle it.