Chrysler Conquest 1988 Service Manual page 655

-
Service Adjustment
AUTOMATIC SPEED CONTROL (ASC) SYSTEM - Procedures
14-127
KICKDOWN SWITCH ADJUSTMENT
(1) Loosen the lock nut.
(2) Turn the kickdown switch to adjust it so that when pedal
stroke is between 36 and 38 mm (1.4 and 1.5 in.), switch I is
ON and when pedal stroke is between 45 and 49 mm (1.8
and 1.9 in.), switch II is ON.
NOTE
Make sure that overall pedal stroke is 57 mm (2.2 in.) or
more.
(3) After adjustment of kickdown switch, move the spring
holder to make adjustment so that as soon as the switch I
of kickdown switch is ON, the pin of accelerator arm may
contact the spring.
ON
+ SET
to
ON
Indicator
to
RESUME
68Y531
SPEED CONTROL SYSTEM CHECK
MAIN SWITCH CHECK
1. Turn the ignition key to ON.
2. Check that the indicator lights when the MAIN switch is set
to ON.
SPEED CONTROL SET CHECK
1. Set the MAIN switch to ON.
2. Run the vehicle at a desired speed over approximately 40
km/h (25 mph).
3. Press the SET switch of the control switch.
4. Check that the vehicle runs constantly at the desired speed
when the switch is released.
ACCELERATION SET CHECK
1. Set to the desired speed.
2. Turn the control switch to the RESUME position.
3. Check that acceleration continues while the switch is in the
RESUME position and after release, the vehicle keeps the
speed at which it was running when the switch was
released.