Chrysler Conquest 1988 Service Manual page 747

.
,.
ENGINE
- Valves and Valve Springs
9-47
Enamel
coated
* Spring retainer
zziSL-- Valve stem
sea'
3EN32.r
SERVICE POINTS OF REASSEMBLY
NOSPKCA
15.7. INSTALLATION OF VALVE STEM SEAL / 13. 5.
VALVE SPRING SEAT
Install the spring seat, then using the special tool, install the
stem seal by lightly tapping the tool. Seal is installed in
specified position.
Caution
1. Incorrect installation of the seal without using the
special tool will result in poor sealing and cause oil
leakage down valve guide.
2. Do not reuse stem seal.
14. INSTALLATION OF EXHAUST VALVE / 6. INTAKE
VALVE
Apply engine oil to each valve. Insert valves into the valve
guides. Avoid inserting the valve into the seal with force.
After insertion, check to see if the valve moves smoothly.
12.4. INSTALLATION OF VALVE SPRING
Valve springs should be installed with the enamel.coated
side toward the valve spring retainer.
*
INSTALLATION OF RETAINER LOCK 10.2
(1 ) Using the special tool, compress the valve spring and
install the retainer lock.
Caution
When compressing the spring with the Valve
Spring Compressor, check to see that the valve
stem seal is not pressed to the bottom of the
retainer. Then start installing the retainer lock.
(2) Make certain that retainer locks are positively installed.
1. INSTALLATION OF JET VALVE ASSEMBLY
(1) Apply engine oil to the O-ring, jet body threads and seat
surface.
Caution
Make sure that the O-ring is a new one.