Chrysler Conquest 1988 Service Manual page 1013

LUBRICATION AND MAINTENANCE
- Maintenance Service
o-15
Correct
Incorfect
bb
lEL160
lEL161
Hexagon nut
03E58(
IGNITION CABLES (Replace)
NOOSAPA
The ignition cables should be replaced periodically with new
ones. After replacing, make sure that the ignition cables and
terminals are properly connected and fully seated.
NOTE
When disconnecting an ignition cable, be sure to hold cable
cap. If the cable is disconnected by pulling on the cable alone,
an open circuit might result.
OXYGEN SENSOR (Replace)
NOOSAQA
The oxygen sensor is a device which controls the fuel mixture.
If the oxygen sensor is damaged, the exhaust-gas cleaning
effect as well as driveability deteriorates. Therefore, it should
be replaced periodically with a new one.
DRIVE BELT (Replace)
NOOSBBA
Replace the drive belts with new ones, and make sure there is
no interference between the belt and other engine compo-
nents.
Then, check the tension of the belt for the water pump and
alternator. The deflection of the belt must be specified listed
below when depressed at a point midway between the water
pump pulley and the alternator pulley with a force of 100 N (22
Ibs.).
(1) Remove the air conditioner compressor belt and/or power
steering oil pump belt if equipped.
(2) Loosen the alternator support bolt nut.