Chrysler Conquest 1988 Service Manual page 1105

STEERING - Steering Column and Shaft
19-19
Steering shaft bearing
I
I
+ : Multipurpose grease
+ : Adhesive
13F5OC
INSPECTION
NlSGGAG
l
Check tilt bracket for cracks and damage.
l
Check column bushing for damage.
l
Check steering shaft bearing for wear.
l
Check steering shaft for damage and deformation.
l
Check joint cover for wear.
l
Check joint bearing for wear and damage.
Steering shaft length: 727 mm (28.62 in.)
SERVICE POINTS OF REASSEMBLY
NllGHAL
25. INSTALLATION OF STEERING LOCK
When the steering lock is to be installed to the column,
temporarily install the steering lock in alignment with the
column boss, and, after checking that the lock works
properly, tighten the special bolts until the heads twist off.
'20. INSTALLATION OF COLUMN TUBE CLAMP
Attach the column bushing to the upper and lower column
tubes, and secure the upper tube with the clamp.
NOTE
Install the clamp so that the bolt tightening part of the
clamp is at the bottom.
16. INSTALLATION OF STEERING SHAFT BEARING
(1) Apply the specified grease to the inside of the steering
shaft bearing, and then insert the steering shaft into the
bearing.
Specified grease: MOPAR Multi-mileage Lubricant
Part No. 2525035 or equivalent
(2) Apply specified adhesive to the surface where the
steering shaft bearing and the column tube contact.
(3) Apply the specified grease to the inside of the upper
bearing.
Specified grease: MOPAR Multi-mileage Lubricant
Part No. 2525035 or equivalent
(4) Install the steering shaft with the steering shaft bearing
in the column tube.