Chrysler Conquest 1988 Service Manual page 1124

STEERING
- Steering Linkage
STEERING LINKAGE
NlSVG-.
DISASSEMBLY AND REASSEMBLY
40-60
Nm
06
87
20
Nm
14 ft.lbs.
Tie rod assembly disassembly steps
l +
Measurement of tie rod end ball joint starting
torque
1. Dust cover
2.
O-ring
I)+ 3. Tie rod outer end
I)+ 4. Tie rod inner end
I)* 5. Tie rod
Relay rod disassembly steps
6. Dust cover
7. CRing
8. Stopper bolts
9. Relay rod
4
50-55
Nm
36-40
ft.lbs.
1311505
Idler arm disassembly steps
*)+
Measurement of Idler arm starting torque
IO. Idler arm attaching nut
'I I, Oil seal
12. Idler arm bearing
.I 3. Idler arm
14. Pin -
15, Oil seal
16. Idler arm bearing
'I 7. Idler arm support
NOTE I
(I 1 Reverse the disassembly procedures to reassemble.
12) *+: Refer to "Service Porn& of Reassembly".
13) a: Non-reusable parts
INSPECTION
NlSVHAA
* Check the idler arm support tor damage and deformation.
+ Check the Idler arm for damage and deformation.
* Check the idler arm beat-mgs tor wear and
cracks.
l
Check the dust covers and O-rings for damage and cracks.
@ Check the tie rods for damage and detormatlon.
@ Check the relay rod for bends and damage.