Chrysler Conquest 1988 Service Manual page 1209

AUTOMATIC TRANSMISSION - Automatic Transtiission Assembly
21-87
J ATOSC
nshift solenoid
Vacuum diaphragm
JAT051
JATO5:
JATO51
L
JAT05E
13.
Remove drum support from O.D. case.
14. Remove downshift solenoid, vacuum diaphragm, rod and
O-rings.
15. Remove speedometer pinion from rear extension.
16. Remove oil pan and inspect its contents. An analysis of any
foreign matter can indicate the types of problems to look
for. If the fluid is very dark, smells burned, or contains
foreign particles, the frictional material (clutches, band) may
need replacement. A tacky film that will not wipe clean
indicates varnish' build up which can cause valves, servo
and clutches to ',stick and may inhibit pump pressure.
17. Remove control valve body.
Remove manual valve from valve body as a precaution, to
prevent valve from dropping out accidentally.
18. Loosen 2nd band servo piston stem lock nut and tighten
piston stem. If it turns more than two turns, the band is
worn out. Back off band servo piston stem to release band.