Chrysler Conquest 1988 Service Manual page 1214

21-92 AUTOMATIC TRANSMISSION
- Automatic Transmission Assembly
2. Lubricate andinstall. low and reverse piston rnto the case.
:
3. Install thrust ring, piston return spring, thrust washer and i
one-way clutch inner r-acme.
_
4. Tighten inner race attaching bolts to specrtred torque using
the special taoI.
Caution
Check that return spring is centered on race before
tightening.
One-way clutch inner race tightening bolt:
13 - 18 Nm (9 - 13 ftlbs.)
-
5. Install steel dished plate first, then steel and friction plates,
and, finally, t-etarning plate and snap ring.
6~. After low and reverse brake has been completely assem-
bled, measure clearance .between snap ring and retainer -
plate. If mesurement e%ceeds specifications it can be
adjusted by replacing retainer plate with one of adifferent ._
thickness. -~
-~
Standard value: 0.80 - 1.25 mm (.031 - .049 in.)