Chrysler Conquest 1988 Service Manual page 1233

AUTOMATIC TRANSMISSION -
Direct Clutch and High-Reverse Clutch
21-111
J
i
?
//////a
15mm
t.059 in.)
1'
t.79 in.)
Cut off hatched portion.
JATOS:
JAT094
Air is blocked here.
I
\
\
.lATl-W
JAT096
JAT097
When tool is to be used, cut toe-tips of three legs with a
grinding wheel.
4. Remove spring retainer and springs.
5. For easy removal of piston from drum, mount clutch on
drum support. Use an air gun with a tapered rubber tip to
carefully apply air pressure to loosen piston from drum.
6. Check clutch drive plate facing for wear or damage. Drive
plate thickness must not be less than limit.
Drive plate thickness
Standard value: 1.50 - 1.65 mm (.0591 - .0650 in.)
Limit: 1.4 mm (.055 in.)
7. Check for wear on snap ring, weak or broken coil springs, -
and warped spring retainer.
8. Check the operation of check ball in piston by applying air
pressure.
REASSEMBLY
1. Lubricate clutch drum hub and seals, and install inner seal
and piston seal as illustrated. Be careful not to stretch seals
during installation.
Never assemble clutch dry; always lubricate its compo-
nents thoroughly.
2. Assemble piston, being careful not to allow seal to kink or
become damaged during installation. After installing, turn
piston by hand to ensure that there is no binding.