Chrysler Conquest 1988 Service Manual page 991

i INTAKE AND EXHAUST SYSTEM
- Exhaust Manifold
11-9
EXHAUST MANIFOLD
REMOVAL Ai)lD INSTALLATION
I
/
Removal steps!
+I)
l
+ 1. Turbocharaer
4. Exyust manifold gasket
/
NOTE
(I) Reverse the jernoval procedures to reinstall.
(2)
(3)
*I): Refer to PService Points of Removal".
I)+: Refer to YService Points of Installation".
NllNJ--
I
OlY689,
I
SERVICE POINT OF REMOVAL
NllNEAJ
1.
REMOVAL OF TURBOCHARGER
Refer to P.l l-IO.
INSPECTION
NllNCAB
EXHAUST MANIFOLD
Check the points described below; replace the part if a problem
is found.
(1) Damage or cracking of any part.
(2) Check, by using a straight edge and feeler gauge, for
.
distortion of the cylinder head lnstallatlon surtace.
Standard value: Less than 0.15 mm (.0059 in.)
Limit:
0.3
mm
(.012
in.)
EXHAUST MANIFOLD GASKET
Gasket may be reused if it has no peeled-off or damaged
surface.
SERVICE POINT OF INSTALLATION
1. INSTALLATION OF TURBOCHARGER
Refer to P.ll-IO.
NllNDAC
-i-
.-
/