Chrysler Conquest 1988 Service Manual page 1062

REAR AXLE - Differential Carrier
(3) Measure the thickness of the stde bearing sdjustrng ~I
spacers on one side, select two pairs of spacers which
correspond to that thickness plus one half of the 1:
clearance~plus 0.05 mm LOO2 in.), and then install one ;
pair each to the drive pinion side and the~drive gear side.
NOTE
+
0.05 mm
Be sure that there isDo clearance betweenAh-e gear ..-3---
l.002 in.)
carrier and the side bearing adjusting spacer.
-A
= il~~ngs of the spacer on
1 lY2L
(4) Install the side bearing-adjusting spacers and differential -.I
case assembly, as shown in the illustration, to the gear ~_
carrier.
-
(5) Tap the side bearing adjustrng spacers with a brass bar T
to fit them to the side bearing outer race.
(6)
Align the mating
bearing czp, and
marks on the gear carrier and ~the =+
then tighten the bearing cap.
(7) Measure the final drive gear backlash.
Standard value: 0.13 - 0.18 mm (.005 - .007 in.)