Chrysler Conquest 1988 Service Manual page 1110

STEERING -
Power Steering Gear Box
SERVICE POINTS OF DISASSEMBLY
N19NFAO
4. REMOVAL OF PITMAN ARM
Remove the pitman arm-from the gear box assembly by
using the special tool.
5. REMOVAL OF SIDE COVER
Loosen the lock nut of the adjusting bolt and screw in the
.
adjusting bolt-so that the side cover may be raised slightly.
-
7. REMOVAL OF CROSS-SHAFT
With the mainshaft and cross-shaft placed-in the neutral.
position, tap the bottom of the cross-shaft~with a plastic
hammer to take out the cross-shaft together with the side _
cover.
8. REMOVAL OF ADJUSTING BOLT
Remove theside cover IFy turning the adjustin-g bolt.
IO. REMOVAL OF U-PACKING (SIDE COVER SIDE)
(1) Remove the needle bearing rollers manually from the ~~
side cover.
(2) Remove the O-ring and U-packing.
NOTES -I- -
Unless there are fluid leaks from the Iadjusting bolt
threads, do not remove the U-packing. If removed, be ~
sure to use new U-packing.
14. REMOVAL OF VALVE HOUSING LOCK NUT
Remove the valve housing lock nut by using the special
tool.
15. REMOVAL OF VALVE HOUSING
Remove the valve housing together with the rack piston.
Caution
Use care not to drop the rack piston.
-
16. REMOVAL OF RACK PISTON
Remove the rack piston from the mainshaft by turning it
counterclockwise.
Caution
Be careful not to lose the 26 balls inside the rack piston.