Chrysler Conquest 1988 Service Manual page 1027

REAR AXLE
- Smcifications
SERVICE SPECIFICATIONS
NOBCE-
_
Items
Standard value
Specifications
Limited slip differential axle shaft turning
torque Nm (ft.lbs.)
Setting of D.O.J. boot length
mm (in.)
Final drive gear backlash mm (in.)
Drive pinion rotating torque
with oil seal Ncm (in.lbs.)
without oil seal Ncm (inlbs.)
Difference in total thickness between left and
right clutch plate mm (in.)
Clearance betweenAh; ;$ch plates and the
differential case
Clutch plate preload
39 (28) or more
83 3~ 3 (3.3 + .12)
0.13 - 0.18 (005 - .007)
40 - 50 (3.5 - 4.3)
15 - 25 (1.3 - 2.2)
0.05 (.002)
0.06 - 0.20 (002 - .008)
when equipped with new clutch plates
Nm (ft.lbs.)
when equipped with old clutch plates
Nm (ftlbs.)
Limit
Rear axle total backlash mm (in.)
Drive gear runout mm (in.)
Axle shaft end play mm (in.)
Torque tube companion flange runout
mm (in.)
Spline coupling runout
mm (in.)
Clutch plate wear
50 - 80 (36 - 58)
35 - 80 (25 - 58)
5 (2)
0.05 (002)
0.8 (031)
0.1 (004)
0.1 (004)
Difference in the thicknesses of the friction
surface and the projection mm (in.)
Flatness of the friction plates and friction
discs mm (in.)
0.1 (004)
0.08 (.003)
TORQUE SPECIFICATIONS
NOBCC-
-
Items
Nm
ft.lbs.
Axle shaft companion flange 260 - 300
188-217
Drive shaft to axle shaft companion flange 55-65 40-70
Rear axle housing to caliper support
40-50
29-36
Torque tube companion flange
160-220 116- 159
Propeller shaft to torque tube 50-60
36-43
Torque tube to front support
35-45 25-33
Torque tube to differential carrier 70-85 51 -61
Lower control arm shaft 70-80
51-58.
Axle housing to lower control arm 15-20 II-14
Strut assembly to axle housing 50-70 36-51
Axle housing mounting nut 50-70 36-51
Rear support protector to insulator 30-35 22-25
Rear insulator to crossmember
25-30 18-22
Differential carrier to spline coupling 190-250
137- 181