Chrysler Conquest 1988 Service Manual page 1065

REAR AXLE
- Differential Carrier
3-47
11 Y641
11 S65E
SERVICE POINT OF DISASSEMBLY
NOBIPBA
1. REMOVAL OF SCREW
(1) Loosen screws of the differential cases (A) and (B)
uniformly a little at a time.
(2) Separate differential case (A) from differential case (B).
(3) Remove the components from differential case (B).
NOTE
Keep the right and left parts separate in order to be able
to distinguish them for reassembly.
INSPECTION
NOBIQBA
l
Check side gears, pinion gears and pinion shaft for wear or
damage.
l
Check the side gear spline for wear or damage.
INSPECTION OF THE CONTACT AND SLIDING SURFACES
OF PARTS
(1) Inspect the friction plate, friction disc, spring plate, spring
disc and pressure ring.
A.
B.
C.
D,
The friction surfaces of the friction plate, friction disc,
spring plate, and spring disc.
If there are any signs of seizure, severe friction, or
colour change from the heat, it will adversely affect the
locking performance; replace the part with a new one.
NOTE
The strong contact on the inner circumference of the
friction surfaces is because of the spring plate and the
spring disc; this wear is not abnormal.
The six projections on the inner circumference of the
friction disc.
If there are nicks and dents, it will cause abnormalities
in the clutch pressure.
Repair the parts by using an oil stone; if the parts
cannot be repaired, replace them.
The four projections on the outer circumference of the
friction disc.
If there are nicks and dents, it will cause abnormalities
in the clutch pressure.
Repair the parts by using an oil stone; if the parts
cannot be repaired, replace them.
The friction surface of the friction disc of the pressure
ring.
If there are nicks or scratches, repair the part by first
grinding with an oil stone and then polishing with
rubbing compound on a surface plate.
NOTE
The strong contact on the inner circumference of the
friction surface is because of the spring plate and the
spring disc; this wear is not abnormal.