Chrysler Conquest 1988 Service Manual page 1104

19-18
_-.
,1 !~T; ,.,.
8,
Ed.
P-=
Ed
EC=
STEERING
- Steering Column and Shaft
E~C
s ;
=a 81=~
d Lo
Steering shaft bearing
F13517
SERVICE POINTS OF DISASSEMBLY
Eye
NWGFAG
B-Es
4. REMOVAL OF STEERING SHAFT ASSEMBLY
z
I ~~
(I) Take out the steering shaft bearing from t.he lower .=
column tube.
(2) Remove the snap ring of the upper column shaft with
snap rings pliers,
(3) Take out the steering shaft from the colutii-~ tube. my=
-
6. REMOVAL 0-F JOINT PIN RETAINER
(1) Slide off the- joint co%% from the socket assembly.
(2) Remove the stoppers, and pull out the joint pin retainer.
8. REMOVAL OF JOINT PIN A
(I) With the-steering shaft set upright, pull out joint pin A
on both sides of the socket, by utilizing a magnet, while
holding the shaft downward.
-
(2) Remove the joint sodket.
Caution
Be sure to use a magnet to remove joint pin A.
Striking the pin with a hammer will make it
unremovable.
43. REMOVAL OF JOINT PIN B
(1) If necessGv, press OC& joint pin B from the steering
shaft and-ta~ke out the joint bearing.
(2) Take out~fhe joint cover and steering shaft bearing.
--
25. REMOVAL OF STEERING LOCK
If it is necessary to remove the steering lock, cut a groove ~:
on the head of the spec~ial bolt with a metal saw, and
remove the steering lock with a screwdriver.
~-
Caution
The steering lock bracket (upper) and bolts should be
replaced with new ones without fail when installing the
steering lock.
-
-