Chrysler Conquest 1988 Service Manual page 1135

MANUAL TRANSMISSION - Gearshift Lever Assembly
GEARSHIFT LEVER ASSEMBLY
21-9
NZlGA-.
REMOVAL AND INSTALLATION *
4
Removal steps
**
1.
Gearshift lever knob
2. Spool release lever
091643
3.
Cover
4. Inner box
5. Rear console box
6.
Side console cover
7. Front console box
8. Dust cover retaining plate
NOTE
*I)
9. Gearshift lever assembly
(1) Reverse the removal procedures to reinstall.
(2) +I): Refer to "Service Points of Removal".
ow34:
SERVICE POINT OF REMOVAL
NZIGBAA
9. REMOVAL OF GEARSHIFT LEVER ASSEMBLY
(1) Remove the bolts attaching the control lever cover.
(2) Uncouple stopper plate from extension cover.
;..:.
(3) Remove the gearshift lever assembly by lifting it up.
NOTE
Keep the gearshift lever in the neutral position.
SERVICE POINT OF INSTALLATION
NZlGDAG
1. INSTALLATION OF GEARSHIFT LEVER KNOB
(1) Loosely tighten the nut down to the end of threaded
portion of the shift lever. Then back off the nut about a
half turn and install the spring washer.
(2) Give one turn to the knob after the spring washer
begins to bend. Tighten further the knob until the shift
pattern faces toward the front of vehicle and adjust.
NOTE
If the knob has been fully tightened by the above
procedure, back off it not more than one turn and make
adjustment.