Chrysler Conquest 1988 Service Manual page 1234

21412
AUTOMATIC TRANSMISSION -
Dir&t Clutch and High-Reverse Clutch
,./--J
,.-_ '
i
..-
JATOSE
High-reverse clutch
te
JATUO~I
'i.--- A"
JATIOC
!I
3. Reassemble sprrng and retainer. Reinstall snap ring. Be _
sure snap ring is properly seated.
-
--
4. Install dish plate with dish facing outward.
5. Now install driven plate (steel plate), then a drive plate
(friction plate) and repeat in this order until correct number _ _
of plates has been installed (check ServiceSpecifications
for proper quantity of plates). Now install retainerplate and
snap ring.
-.
6. Measure clearance between retarner plate and snap rrng. _x
Standard value:
Direct 1.6 - 1.8 mm (.063 - .071 in.)
High-reverse 1.6 - 2.0 mm I.063 - .079 in.)
If necessary, try other retaining plates having different
thicknesses until correct- clearance is obtained.
Available Retaining Plate for High-Reverse Clutch
Thickness mm (In.1 Part number
5.0 (.19i
MD6TD366
5.2 (205) MD610367
5.4 i.213) MD610368
5.6 (2201
MD61~036S~F
5.8 (228) MD61 0375
6.0 (23-6) MD610371
6.2 (.244) MD610372
Available Retaining Plate for Direct Clutch
Thickness mm (In.1 Part number
5.6 t.220) MD61 0252.
5.8 t.228)
MD61 02&
6.0 f.236)
MD610254
6.2 (.244)
MD61 0255
6.4 i.252) MD61 0256
6.6 t.260) MD610257
6.8 l.268)
MD61 0258
7.0 t.276)
-
MD61 0259
I