Chrysler Conquest 1988 Service Manual page 382

I,
--__
8-132
STARTING SYSTEM
- Starter Motor
LOOE
16Yl J 75
16Y3662 16Y298C
1
RETURN TEST OF MAGNETIC SWITCH
(1) Disconnect field coil wire from M-terminal- of magnetic ;--I
L
switch.
(2) Connect a 12V battery between M-terminal and body.
Caution
_
This test must be performed quickly (in less than 10
seconds) to prevent coil from burning.
(3) Pull pinion out and release, If pinion quickly returns to its
_
original position, everything is in order. If it doesn't,- replace
magnetic switch.
I-
..-
STARTER INHIBITOR RELAY
(1) Remove the starter inhibitor relay from the relay box in the = ._
engine compartment.
(2) Check
c on rnurty between termrnals when the battery _~-
t- ~~
voltage is applied to the terminal 2 and the,; termjnal 5. is ~2
earthed.
Voltage applied
Voltage not
applied
Terminals 3 - 6
Terminals3 - 6
Terminals 1 -- 3
TerminalFZ - 5
Conductive
Non-conductive
Conductive
--
SERVICE POINT OF INSTALLATION
2. INSTALLATION OF STARTER MOTOR
Clean both surfaces of starter motor flange and rear plate.
-