Chrysler Conquest 1988 Service Manual page 1114

19-28
STEERING
- Power Steering Gear Box
13S65C 1
(4) Tighten the-valve housing lock nut by using the special
tool.
Caution
Be sure that the top cover does not turn together
with the lock nut at this time.
(5) Measure~Ihe mainshaft starting torque' by using the =-
special tools.
-
Standard value: 25 - 65 Ncm (2 - 6 in.lbs.)
(6) If the measured mainshaft starting torque does not
comply with the standard value, remove the valve
housing lock nut and adjust the tightening of the top
cover.
, -
" - ~ ~
15. INSTALLATION OF RACK PISTON
(1) Install the rack piston until it comes in contact With the
adge of themmainshaftr
- (2) Rotate the mainshaft to align the ball raceway with the
ball insertion- hole.
16. INSTALLATION OF U-PACKING (PITMAN ARM) / 17.
OIL SEAL
Install the U-packing on the-gear box and press-fit the oil
seal.
18. INSTALLATION OF VALVE HOUSING
(I) Apply specified automatic transmission fluid to the seal
rq of the rack piston. -
Specified fluid: MOPAR DEXRON or DEXRON II
Automatic Transmission Fluid Part
No. 3649660 or 4131509, or equiva-
lent
(2) Install the valve housino
0) Rotate the niainshaft unf? the rack piston moves to the
neurral position (center).
-