Chrysler Conquest 1988 Service Manual page 592

7-4
COOLING - Specifications
SPECIFICATIONS
NO'ICA-
.
GENERAL SPECIFICATIONS
Radiator cap
Pressurized corrugated fin type
High pressure valve opening pressure
Vacuum valve opening pressure kPa (psi)
Radiator fan motor No. 1
Rated load torque
Ncm (inlbs.)
rpm (with the fan attached)
rpm
Current A
Radiator fan motor No. 2
(Vehicles with a manual transmission)
Rated load torque
Ncm (in.lbs.)
rpm (with the fan attached)
wm
Current A
Radiator fan motor No. 2
[Vehicles with an automatic transmission)
Type
Rated load torque Ncm (in.lbs.)
rpm (with the fan attached)
rpm
Current A
Thermosensor No. 2
Operating temperature
"C ("F)
OFF -+ ON
ON + OFF
Thermosensor No. 2
Operating temperature "C ("F)
OFF% ON
ON + OFF
?adiator fan motor relay
Excitingcoil rated current A
Maximum contact current capacity A
Range of voltage used V
Voltage drop between terminals V
Water pump
Thermostat
Type
Valve opening temperature "C ("F)
Full-opening temperature "C ("F)
Identification mark
Xve belt
Length
mm (in.)
Direct current ferrite magnet type
1,750-2,250 :
Direct current ferrite magnet type
Direct current ferrite magnet type
1,750 - 2,250
82-88(180-190)
78- 87 (172 - 189)
97- 103 (207 --Zl7)
9X- 102 (199-216)
0.074 - 0.106 -~
0.2 or less +
' Impeller of centrifugal type
Wax type with jiggle valve
88(190)
1 OII (212) at valve lift of 8 mm (.3l in.)
88 (Stamped on flange)
964 (37.95) HM type