Chrysler Conquest 1988 Service Manual page 267

INSPECTION OF HARNESS CONNECTOR -
Inspection of Harness Connector
8-13
Housing lance
16R132'
A Needle
16Rl32:
Housing lance
16R1323
16Fil32~
(2) Insert harness of terminal to be rectified deep into
connector from harness side and hold it there.
(3) Insert tip of screwdriver [I.4 mm (.06 in.) width] into
connector in a manner as shown in the figure, raise housing
lance slightly with it and pull out harness.
NOTE
Tool No. 753787-l supplied by AMP can be used instead of
screwdriver.
(4) Insert needle through a hole provided on terminal and raise
contact point of male terminal.
ROUND WATERPROOF CONNECTOR
(1) Remove waterproof cap by using a screwdriver.
(2) Insert tip of screwdriver [I4 mm (.06 in.) or 20 mm (.08 in.)
width] as shown in the figure, raise housing lance slightly
with it and pull out harness.
(3) Insert screwdriver through a hole provided on terminal and
raise contact point of male terminal.