Chrysler Conquest 1988 Service Manual page 1151

MANUAL TRANSMISSION
- Extension Housing
21-27
EXTENSION HOUSING
NZlQE- -
DISASSEMBLY AND REASSEMBLY
Disassembly steps
** l + 1. Lock pin
l * l * 2. Spring pin
Control flange and control shaft
Neutral return finger
Change shifter
Dust seal guard
Oil seal
Extension housing
. .
. .
l8 NOTE
(I) Reverse the disassembly procedures to reassemble.
(2) (2)
(3) (3)
*I): Refer to ':Service Points of Disassembly". *I): Refer to ':Service Points of Disassembly".
(4) (4)
l *: Refer to "Service Points of Reassembly". l *: Refer to "Service Points of Reassembly".
q
: Non-reusable parts
q
: Non-reusable parts
132040 132040
.
Neutral return
Change shifter
- Oil seal
Apply oil
132041
SERVICE POINTS OF DISASSEMBLY
NZlQFA-
-
1. REMOVAL OF LOCK PIN / 2. SPRING PIN
To remove control shaft from extension housing, remove
lock pin from neutral return finger and remove spring pin
from change shifter with the special tool, Lock Pin
Extractor. Then remove control shaft toward front of
housing.
NZlQHAA
SERVICE POINTS OF REASSEMBLY
7. INSTALLATION OF OIL SEAL
(1) Apply oil to lip of oil seal.
(2) Install oil seal with lip toward front of housing.
2. INSTALLATION OF SPRING PIN / 1. LOCK PIN
Align pin holes of control shaft, neutral return finger and
change shifter and using the special tool, Lock Pin Installer,
install lock pin and spring pin.
NOTE
Do not reuse spring pin.